König SATA Specifications download pdf (Page 3)

Press the power button.

The Mode LED will go on.

Once both drives are installed, press the “duplicate start” button. The mode LED will be flashing, wait for

5 seconds; the mode LED will go out and then press the start button again to confirm the duplication process.

You will see the HDD’s active LED flashing until the whole duplication is complete. When the duplication is

successfully finished, all the LEDs go out.

LED indication

Power

Target HDD

Source HDD

Power

Safety precautions:

To reduce risk of electric shock, this product should ONLY be

opened by an authorized technician when service is required.

Disconnect the product from mains and other equipment if a

problem should occur. Do not expose the product to water or

moisture.

Maintenance:

Clean only with a dry cloth. Do not use cleaning solvents or abrasives.

Warranty:

No guarantee or liability can be accepted for any changes and modifications of the product or damage caused

due to incorrect use of this product.

General:

Designs and specifications are subject to change without notice.

All logos brands and product names are trademarks or registered trademarks of their respective holders and

are hereby recognized as such.

Keep this manual and packaging for future reference.

Attention:

This product is marked with this symbol. It means that used electrical and electronic products should

not be mixed with general household waste. There is a separate collections system for these products.

1 2 3 4 5 6 7 8 ... 29 30

No comments

König SATA Specifications Page 3