König DL-QUAKE250 Specifications download pdf (Page 2)

ENGLISH

INTRODUCTION:

This advanced DMX controllable multi-color light effect has 12 different rotating gobo patterns and a

special feature called gobo shaking. The 250W halogen lamp ensures a room lling effect. This light

effect is ideal for permanent installation or mobile use

IMPORTANT INFORMATION BEFORE USE:

The QUAKE250 is not for household use. It is not a toy: it presents risks of serious injury due to

electric shock, high heat, and intense light. For safe operation, read this manual before using the

xture and observe all warnings and precautions printed here and on the xture. If you have questions

about how to operate the xture safely, please contact your König distributor or dealer.

Precautions:

• For protection against dangerous electric shock, the xture must be grounded (earthed). The AC

mains supply shall be tted with a fuse or circuit breaker and ground-fault protection.

• The xture operating voltage is printed on the rating label. Verify that the operating voltage closely

matches the AC supply voltage before connecting the xture. Do not connect the xture if the

voltage on the label differs from the AC mains voltage by more than ve percent.

• Verify that all used power cables are undamaged and rated for the current requirements of all

connected devices before use.

• There are no user serviceable parts inside except the lamp. Refer all service to a qualied

technician.

• Replace the lamp if it becomes defective or worn out. Allow the xture to cool for 15 minutes before

installing a new lamp and make sure the xture is disconnected from the AC mains supply.

• Keep all combustible materials (for example fabric, wood, paper) at least 50cm (20 inches) away

from the xture. Keep ammable materials well away from the xture.

• Provide a minimum clearance of 10cm (4 inches) around the fan and air vents.

• When suspending the xture above ground level, verify that the structure can hold at least 10 times

the weight of all installed devices and secure the xture with an approved safety cable. Block

access below the work area whenever installing or removing the xture.

• When carrying the xture, lock the mounting bracket securely and do not touch the lens or mirrors.

• Do not expose the xture to rain or moisture.

• Do not illuminate surfaces within 1 meter (39 inches) of the xture.

• Do not operate the xture if the ambient temperature exceeds 40°C (104°F).

• Never place lters or other objects over the lens or mirrors.

Important! Electric dimmers may damage the electronic components.

Although the QUAKE250 cannot be dimmed, it may be switched on and off remotely using switch

packs or the full-on and full-off levels on dimmer packs.

INSTALLATION:

The best way to hang the QUAKE250 is to use a rigging clamp. Bolt the clamp securely to the

mounting bracket. Verify that the structure can hold at least 10 times the weight of all installed devices

and secure the xture with an approved safety cable. Change to the desired angle by adjusting the

mounting bracket and tighten both swivel locks.

Install the xture at least 50cm (20 inches) away from combustible materials. Keep ammable

materials well away from the xture. Make sure the xture does not illuminate surfaces within 1 meter

(39 inches).

To ensure maximum lamp life, provide a minimum clearance of 10cm (4 inches) around the fan and air

vents. Make sure the ambient temperature will not exceed 40°C (104°F) and do not place the xture

on or nearby a loudspeaker.

DL-QUAKE250_A5.indd 2 2009.9.1 9:33:30 AM

1 2 3 4 5 6 7 ... 76 77

Comments to this Manuals

No comments

König DL-QUAKE250 Specifications Page 2

Comments to this Manuals